Test Directions for the One Step Specimen Validity Tests

Allow Test Card & Urine Specimen to reach room temperature (15-300C) prior to testing.
- When ready to perform the test, remove the test from the pouch or container. Dip test strip into the urine specimen & remove immediately.
- Gently blot the test gently on its side to remove excess urine. Note: It is important to blot the test strip for consistent results.
- Read results in one (1) minute by comparing each pad with the color chart supplied. Do not interpret results after 4 minutes.
Color Chart

LIMITATIONS:
- The One Step test Strip provides only a qualitative, preliminary analytical result. A secondary analytical method must be used to obtain a confirmed result. Gas Chromatography/Mass Spectrometry (GC/MS) are the preferred confirmatory methods.
- It is possible that technical or procedural errors, as well as other interfering substances in the urine specimen may cause erroneous results.
- Adulterants, such as bleach and/or alum, in urine specimens may produce erroneous results regardless of the analytical method used. If adulteration is suspected, the test should be repeated with another urine specimen.
- Certain medications/pharmaceuticals/compounds may produce a Positive Result.
- A Positive Result indicates presence of the drug or its metabolites but does not indicate level of intoxication, route of administration or concentration in urine.
- A Negative Result may not necessarily indicate drug-free urine. Negative Results may be obtained when drug is present but below the cutoff level of the test.
- Test does not distinguish between drugs of abuse & certain medications.
DrugTestStrips.com products have been found to be highly accurate and are guaranteed against defects in labeling & packaging until the stated expiration date. Regardless, DrugTestStrips.com will not be held accountable/liable for the outcome of ANY result arising from the use of DrugTestStrips.com products. DrugTestStrips.com sole obligation in the event of ANY damage/result/defect is to replace it with a comparable new test strip product. Except for such replacement, the sale, transfer, or handling of these drug test products are without warranty, condition or liability even though the damage/result/defect is due to negligence or other fault.







